Super Authentication-Mode - H3C S3100 Series Command Manual

Command Manual (For Soliton) – CLI
H3C S3100 Series Ethernet Switches
User privilege level is 3, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE

1.1.4 super authentication-mode

Syntax
super authentication-mode { super-password | scheme }*
undo super authentication-mode
View
User interface view
Parameters
super-password: Adopts super password authentication for low-to-high user level
switching.
scheme: Adopts Huawei terminal access controller access control system
(HWTACACS) authentication for low-to-high user level switching.
Description
Use the super authentication-mode command to specify the authentication mode
used for low-to-high user level switching.
Use the undo super authentication-mode command to restore the default.
By default, super password authentication is adopted for low-to-high user level
switching.
Note that the two authentication modes are available at the same time to provide
authentication redundancy. When both the two authentication modes are specified, the
order to perform the two types of authentication is determined by the order in which
they are specified, as described below.
If the super authentication-mode super-password scheme command is
executed to specify the authentication mode for user level switching, the super
password authentication is preferred and the HWTACACS authentication mode is
the backup.
If the super authentication-mode scheme super-password command is
executed to specify the authentication mode for low-to-high user level switching,
the HWTACACS authentication is preferred and the super password
authentication mode is the backup.
Chapter 1 CLI Configuration Commands
1-5