Jumboframe Enable - H3C S3100 Series Command Manual

Command Manual (For Soliton) – Port Basic Configuration
H3C S3100 Series Ethernet Switches
The slot number is 0 if the port is an Ethernet port, the slot number is 1 if the port is
a GigabitEthernet port.
The port number is relevant to the device.
Description
Use the interface command to enter specific port view. To configure an Ethernet port,
you need to enter Ethernet port view first.
Example
# Enter Ethernet 1/0/1 port view.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1]

1.1.16 jumboframe enable

Syntax
jumboframe enable
undo jumboframe enable
View
Ethernet port view
Parameter
None
Description
Use the jumboframe enable command to set the maximum frame size allowed on a
port to 2048 bytes.
Use the undo jumboframe enable command to restore the default frame size allowed
on a port.
By default, the maximum frame size allowed on an Ethernet port is 2048 bytes.
Note:
The configuration of jumboframe enable command takes effect on all the ports while
the configuration of undo jumboframe enable takes effect on current port.
Chapter 1 Port Basic Configuration
1-22
Commands