H3C S3100 Series Command Manual page 72

Command Manual (For Soliton) – VLAN
H3C S3100 Series Ethernet Switches
Table 1-2 Description on the fields of the display vlan command
Field
VLAN ID
VLAN Type
Route Interface
IP Address
Subnet Mask
Description
Name
Tagged Ports
Untagged Ports
1.1.4 interface Vlan-interface
Syntax
interface Vlan-interface vlan-id
undo interface Vlan-interface vlan-id
View
System view
Parameters
vlan-id: Specifies the ID of a VLAN interface, in the range of 1 to 4094.
Description
Use the interface Vlan-interface command to create the VLAN interface for a VLAN
and enter VLAN interface view.
Use the undo interface Vlan-interface command to delete a VLAN interface.
You can create a VLAN interface only for an existing VLAN and must ensure that the ID
of the VLAN interface is the same as the VLAN ID.
You can use the ip address command in VLAN interface view (refer to the IP Address
and Performance Command part for the command description) to configure an IP
VLAN ID.
VLAN type (dynamic or static).
Indicates whether the VLAN interface of the VLAN is
configured with an IP address for routing.
Primary IP address of the VLAN interface (available only on a
VLAN interface configured with an IP address). You can use
the display interface vlan-interface command in any view or
the display this command in VLAN interface view to display its
secondary IP address(es), if any.
Subnet mask of the IP address of the VLAN interface.
Description of the VLAN.
VLAN name.
Ports out of which packets are sent tagged.
Ports out of which packets are sent untagged.
1-5
Chapter 1 VLAN Configuration Commands
Description