H3C S3100 Series Command Manual page 658

Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
you want to specify the member manually, you need to specify a number that is never
used by a member device of the cluster.
After you add a candidate device to the cluster, the super password of the device
automatically changes to the super password of the management device. If the
management device changes its super password, the member devices will
automatically synchronize their super passwords to the new super password of the
management device.
Examples
# Add a candidate device, whose MAC address and user password are 000f-e20f-35e7
and 123456 respectively, to the cluster, and set the member number to 6.
<aaa_0.Sysname> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] add-member 6 mac-address 000f-e20f-35e7 password
123456
2.3.2 administrator-address
Syntax
administrator-address mac-address name name
undo administrator-address
View
Cluster view
Parameters
mac-address: MAC address of the management device to be specified.
name: Name of an existing cluster, a string of up to 8 characters. Note that the name of
a cluster can only contain alphanumeric characters, minus signs (-), and underscores
(_).
Description
Use the administrator-address command to specify the management device MAC
address and the cluster name on a device to add the device to the cluster.
Use the undo administrator-address command to remove the management device
MAC address from the MAC address list of a member device, that is, remove the
member device from the cluster. Normally, this command is used for debugging and
restoring purpose.
By default, a switch is not a member of any cluster.
Chapter 2 HGMP V2 Configuration
2-16
Commands