File Prompt - H3C S3100 Series Command Manual

Command Manual (For Soliton) – File System Management
H3C S3100 Series Ethernet Switches
View
System view
Parameter
filename: Batch file, with the extension .bat.
Description
Use the execute command to execute the specified batch file. Executing a batch file is
to execute a set of commands in the batch file one by one.
Note that:
A batch file cannot contain any invisible character. If any invisible character is
found, the system will abort the execution of the batch file, that is, the remaining
commands in the batch file will not be executed, but the executed operations will
not be cancelled.
Not every command in a batch file is sure to be executed. For example, if a certain
command is not correctly configured, the system omits this command and goes to
the next one.
Each configuration command in a batch file must be a standard configuration
command, meaning that the configuration information can be displayed with the
display current-configuration command after this command is configured
successfully; otherwise, this command may not be executed correctly.
Example
# Execute the batch file named test.bat under the directory flash:/.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] execute test.bat
<Sysname>
....
%Created dir unit1>flash:/test3.

1.1.6 file prompt

Syntax
file prompt { alert | quiet }
View
System view
Chapter 1 File System Management
1-7
Configuration Commands