Mirroring-Group Reflector-Port; Mirroring-Group Remote-Probe Vlan - H3C S3100 Series Command Manual

Command Manual (For Soliton) – Mirroring
H3C S3100 Series Ethernet Switches

1.1.5 mirroring-group reflector-port

Syntax
mirroring-group group-id reflector-port reflector-port
undo mirroring-group group-id reflector-port reflector-port
View
System view, Ethernet port view
Parameters
group-id: Number of a port mirroring group, the value of which can only be 1.
reflector-port reflector-port: Specifies the reflector port. reflector-port is available in
system view only, and there is no such argument in Ethernet port view.
Description
Use the mirroring-group reflector-port command to specify the reflector port for a
remote source mirroring group.
Use the undo mirroring-group reflector-port command to remove the reflector port
of a remote source mirroring group.
Note the following when you configure the reflector port:
The reflector port cannot be a member port of an aggregation group, or a port
enabled with LACP or STP. It must be an access port and cannot be configured
with the functions like VLAN-VPN, port loopback detection, packet filtering, QoS,
port security, and so on.
You cannot modify the duplex mode, port rate, and MDI attribute of a reflector port.
It is recommended not to configure the VLAN mapping and the selective QinQ
function on the reflector port; otherwise, port mirroring may not function properly..
Examples
# Configure Ethernet 1/0/2 as the reflector port of remote source mirroring group 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 reflector-port Ethernet 1/0/2

1.1.6 mirroring-group remote-probe vlan

Syntax
mirroring-group group-id remote-probe vlan remote-probe-vlan-id
undo mirroring-group group-id remote-probe vlan remote-probe-vlan-id
1-6
Chapter 1 Mirroring Commands