Probe-Failtimes - H3C S3100 Series Command Manual

Command Manual (For Soliton) – HWPing
H3C S3100 Series Ethernet Switches
By default, the password for logging in to the FTP server is not configured.
Related commands: username and ftp-operation.
Note:
To perform an FTP test successfully, the configured password must be consistent
with the FTP user password configured on the server.
This command applies to FTP tests only.
Examples
# Configure the password for logging into the FTP server as "hwping" in an FTP test.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] hwping administrator ftp
[Sysname-hwping-administrator-ftp] test-type ftp
[Sysname-hwping-administrator-ftp] password hwping

1.1.19 probe-failtimes

Syntax
probe-failtimes times
undo probe-failtimes
View
HWPing test group view
Parameters
times: Number of consecutive failed probes, in the range of 1 to 15.
Description
Use the probe-failtimes command to configure the number of consecutive times the
probe fails before the switch sends out a trap message.
Use the undo probe-failtimes command to restore the default.
By default, the switch sends a trap about probe failure each time when a probe fails.
Examples
# Configure the switch to send a trap after the probe in an ICMP test fails for three
consecutive times.
<Sysname> system-view
1-22
Chapter 1 HWPing Commands