H3C S3100 Series Command Manual page 944

Command Manual (For Soliton) – VLAN-VPN
H3C S3100 Series Ethernet Switches
By default, the VLAN mapping function is disabled.
Note:
A port that is in a link aggregation port group cannot have the VLAN Mapping
feature enabled.
With port-based VLAN mapping rules configured for a port, the VLAN mapping
function is enabled on the port at the same time. In this case, the vlan-mapping
enable command cannot be used to enable the VLAN mapping function again.
The VLAN mapping function and the protocol-based VLAN function are mutually
exclusive on the same port.
Related command: vlan-mapping.
Example
# Enable the VLAN mapping function on Ethernet 1/0/1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] vlan-mapping enable
Chapter 3 VLAN Mapping Configuration Commands
3-3