Sftp Server Enable - H3C S3100 Series Command Manual

Command Manual (For Soliton) – FTP-SFTP-TFTP
H3C S3100 Series Ethernet Switches
[ftp] get test.cfg
......FTP: 1740 byte(s) received in 9.367 second(s) 185.00 byte(s)/sec.
The above output indicates that if the verbose function is disabled, only execution
information of users' operations is obtained from the system of the switch, while the
output information beginning with three-digit numbers cannot be returned to the users.
For the description of the numbers at the beginning of FTP output information, refer to
the corresponding section in RFC 959.
1.3 SFTP Server Configuration Commands

1.3.1 sftp server enable

Syntax
sftp server enable
undo sftp server
View
System view
Parameters
None
Description
Use the sftp server enable command to enable the SFTP server.
Use the undo sftp server command to disable the SFTP server.
By default, the SFTP server is disabled.
Examples
# Enable the SFTP server.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] sftp server enable
%Start SFTP server
1.3.2 sftp timeout
Syntax
sftp timeout time-out-value
undo sftp timeout
Chapter 1 FTP and SFTP Configuration
1-23
Commands