Mac-Authentication Interface - H3C S3100 Series Command Manual

Command Manual (For Soliton) – MAC Address Authentication
H3C S3100 Series Ethernet Switches
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] mac-authentication

1.1.3 mac-authentication interface

Syntax
mac-authentication interface interface-list
undo mac-authentication interface interface-list
View
System view
Parameters
interface-list: List of Ethernet ports. You can specify multiple Ethernet ports by providing
this argument in the form of interface-list = { interface-type interface-number [ to
interface-type interface-number ] } &<1-10>, where &<1-10> means that you can
provide up to 10 port indexes/port index ranges for this argument.
Description
Use the mac-authentication interface command to enable the MAC address
authentication for on the specified port(s).
Use the undo mac-authentication interface command to disable the MAC address
authentication for the specified port(s).
By default, MAC address authentication is disabled on a port.
Note:
This command is essential for MAC address authentication to work on a port or on
particular ports after MAC address authentication is globally enabled.
You cannot configure the maximum number of dynamic MAC address entries for a
port (through the mac-address max-mac-count command) with MAC address
authentication enabled. Likewise, you cannot enable the MAC address
authentication feature on a port with a limit of dynamic MAC addresses configured.
If you have enabled MAC address authentication on a port, you cannot add the port
to an aggregation group. If a port is already added to an aggregation group, you
cannot enable MAC address authentication on the port.
Examples
# Enable MAC address authentication for Ethernet1/0/1 port.
Chapter 1 MAC Address Authentication
1-5
Configuration Commands