Calling-Station-Id Mode - H3C S3100 Series Command Manual

Command Manual (For Soliton) – AAA
H3C S3100 Series Ethernet Switches
Note:
After configuring the accounting-on enable command, you need to execute the
save command so that the command can take effect when the switch restarts.
This function requires the cooperation of the H3C CAMS system.
Related commands: nas-ip.
Examples
# Enable the user re-authentication at restart function for the RADIUS scheme named
radius1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
[Sysname-radius-radius1] accounting-on enable

1.2.3 calling-station-id mode

Syntax
calling-station-id mode { mode1 | mode2 } { lowercase | uppercase }
undo calling-station-id mode
View
RADIUS scheme view
Parameters
mode1: Sets the MAC address format to XXXX-XXXX-XXXX, where each X represents
a hexadecimal number.
mode2: Sets the MAC address format to XX-XX-XX-XX-XX-XX.
lowercase: Uses lowercase letters in the MAC address.
uppercase: Uses uppercase letters in the MAC address.
Description
Use the calling-station-id mode command to configure the MAC address format of
the Calling-Station-Id (Type 31) field in RADIUS packets.
Use the undo calling-station-id mode command to restore the default format.
By default, the MAC address format is XXXX-XXXX-XXXX, in lowercase.
Chapter 1 AAA Configuration Commands
1-34