Habp Server Vlan - H3C S3100 Series Command Manual

Command Manual (For Soliton) – 802.1x-System Guard
H3C S3100 Series Ethernet Switches
If an 802.1x-enabled switch does not have HABP enabled, it cannot manage the
switches attached to it. So, you need to enable HABP on specific switches in a network
with 802.1x enabled.
Example
# Enable HABP.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] habp enable

3.1.5 habp server vlan

Syntax
habp server vlan vlan-id
undo habp server
View
System view
Parameter
vlan-id: VLAN ID, ranging from 1 to 4094.
Description
Use the habp server vlan command to configure a switch to operate as an HABP
server. This command also specifies the VLAN where HABP packets are broadcast.
Use the undo habp server vlan command to revert to the default HABP mode.
By default, a switch operates as an HABP client.
To specify a switch to operate as an HABP server, you need to enable HABP (using the
habp enable command) for the switch first. When HABP is not enabled, the habp
server vlan command cannot take effect.
Example
# Specify the switch to operate as an HABP server and the HABP packets to be
broadcast in VLAN 2. (Assume that HABP is enabled.)
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] habp server vlan 2
3-4
Chapter 3 HABP Configuration
Commands