Display Device - H3C S3100 Series Command Manual

Command Manual (For Soliton) – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches

3.1.5 display device

Syntax
display device [ manuinfo | unit unit-id ]
View
Any view
Parameter
manuinfo: Specifies to display the manufacture information of the specified switch.
unit-id: Unit ID of a switch, the value can only be 1.
Description
Use the display device command to display the information, such as the module type
and operating status, about each board (main board and sub-board) of a specified
switch.
You can use this command to display the following information about each board,
including slot number, sub-slot number, the number of ports, versions of PCB, FPGA,
CPLD and Boot ROM software, address learning mode, interface board type, and so
on.
Example
# Display board information of this switch.
<Sysname> display device
Unit 1
SlotNo SubSNo PortNum PCBVer FPGAVer CPLDVer BootRomVer AddrLM Type
0 0
0 1
0 2
Table 3-3 Description on the fields of the display device command
SlotNo
SubSNo
PortNum
PCBVer
FPGAVer
CPLDVer
BootRomVer
24 REV.A NULL
1 REV.A NULL
1 REV.A NULL
Field
Serial number of the slot
Serial number of the sub slot
Number of ports
Version number of the PCB card
Version number of the FPGA encapsulation
Logical version number of the hardware CPLD
Version number of the Boot ROM
3-4
Chapter 3 Device Management
001 506 IVL
NULL NULL IVL
NULL NULL IVL
Description
Commands
State
MAIN Normal
COMBO TBD Normal
COMBO TBD Normal