H3C S3100 Series Command Manual page 659

Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
A cluster has one and only one management device. Setting the management device
MAC address on a device can add the device to the cluster and enable the device to
identify the management device even if it restarts.
You can add a device to a cluster using the administrator-address command no
matter whether the super password of the device is consistent with that of the
management device.
Normally it is recommended to use the delete-member command on the management
device to remove a member device from the cluster.
Examples
# Remove the current member device from the cluster.
<aaa_1.Sysname> system-view
System View: return to User View with Ctrl+Z
[aaa_1.Sysname] cluster
[aaa_1.Sysname-cluster] undo administrator-address
2.3.3 auto-build
Syntax
auto-build [ recover ]
View
Cluster view
Parameters
recover: Recovers all member devices.
Description
Use the auto-build command to start an automatic cluster building process.
You can execute this command on a management device or on a switch to be
configured as a management device.
When you execute this command on a candidate device, you are prompted to enter a
cluster name to build a cluster. The candidate device will automatically become the
management device of the cluster. Then, the management device will collect candidate
devices and add them to the cluster automatically.
When you execute this command on a management device, the system directly
collects candidate devices ant automatically adds them to the cluster.
The recover keyword is used to recover a cluster. After you execute the auto-build
recover command, the system looks for the down members in the member list and add
them to the cluster again.
Chapter 2 HGMP V2 Configuration
2-17
Commands