Info-Center Loghost Source - H3C S3100 Series Command Manual

Command Manual (For Soliton) – Information Center
H3C S3100 Series Ethernet Switches
This command works only when the information center is enabled.
Note:
Be sure to set the correct IP address in the info-center loghost command. A loopback
IP address will cause an error message, prompting that the address is invalid.
Related command: info-center enable, display info-center.
Example
# Configure the system to output system information to the Unix log host whose IP
address is 202.38.160.1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] info-center loghost 202.38.160.1

1.1.11 info-center loghost source

Syntax
info-center loghost source interface-type interface-number
undo info-center loghost source
View
System view
Parameter
interface-type: Specifies an interface type.
interface-number: Specifies an interface number.
Description
Use the info-center loghost source command to configure the source interface
through which information is sent to the log host.
Use the undo info-center loghost source command to cancel the source interface
configuration.
Related command: info-center enable, display info-center.
Example
# Configure VLAN-interface 1 as the source interface through which information is sent
to the log host.
Chapter 1 Information Center Configuration
1-11
Commands