Display Cluster Base-Members - H3C S3100 Series Command Manual

Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Note:
You can only use this command on the cluster administrative device.
If the device to be added to the blacklist is a member of the cluster, the execution of the
black-list add-mac command will remove the device from the cluster and then add it to
the cluster blacklist. In this case, the black-list add-mac command is equivalent to the
delete-member member-id to-black-list command.
Examples
# Add the device with the MAC address 0010-3500-e001 to the blacklist.
<aaa_0.Sysname> system-view
Enter system view, return to user view with Ctrl+Z.
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] black-list add-mac 0010-3500-e001
# Delete all addresses in the current cluster blacklist.
[aaa_0.Sysname-cluster] black-list delete-mac all

2.4.2 display cluster base-members

Syntax
display cluster base-members
View
Any view
Parameters
None
Description
Use the display cluster base-members command to display the information about all
the devices in the base cluster topology, such as member number, name, MAC address,
and the current status of each device in a cluster.
Examples
# Display the information about all the devices in the base cluster topology.
<aaa_0.Sysname> display cluster base-members
SN
0
1
Device
aaa_0.Sysname
aaa_1.S3100
Chapter 2 HGMP V2 Configuration
MAC Adress
000f-e200-30a0
000f-e200-86e4
2-46
Commands
Status
UP
UP