Configuring Gvrp Port Registration Mode; Displaying And Maintaining Gvrp - H3C S5600 Series Operation Manual

Table 1-2 Relations between the timers
Timer
Hold
Join
Leave
LeaveAll
The following are recommended GVRP timer settings:
GARP hold timer: 100 centiseconds (1 second)
GARP Join timer: 600 centiseconds (6 seconds)
GARP Leave timer: 3000 centiseconds (30 seconds)
GARP LeaveAll timer: 120000 centiseconds (2 minutes)

Configuring GVRP Port Registration Mode

Follow these steps to configure GVRP port registration mode:
To do ...
Enter system view
Enter Ethernet port view
Configure GVRP port registration
mode

Displaying and Maintaining GVRP

Display GARP statistics
Lower threshold
10 centiseconds
This lower threshold is greater than or
equal to twice the timeout time of the Hold
timer. You can change the threshold by
changing the timeout time of the Hold
timer.
This lower threshold is greater than twice
the timeout time of the Join timer. You can
change the threshold by changing the
timeout time of the Join timer.
This lower threshold is greater than the
timeout time of the Leave timer. You can
change threshold by changing the timeout
time of the Leave timer.
system-view
interface interface-type
interface-number
gvrp registration { fixed |
forbidden | normal }
To do ...
This upper threshold is less than or equal to
one-half of the timeout time of the Join timer.
You can change the threshold by changing
the timeout time of the Join timer.
This upper threshold is less than one-half of
the timeout time of the Leave timer. You can
change the threshold by changing the timeout
time of the Leave timer.
This upper threshold is less than the timeout
time of the LeaveAll timer. You can change
the threshold by changing the timeout time of
the LeaveAll timer.
32,765 centiseconds
Use the command ...
Use the command ...
display garp statistics
[ interface interface-list ]
1-6
Upper threshold
Remarks
—
—
Optional
By default, GVRP port registration
mode is normal.
Remarks
Available in any view