Configuring Gvrp Port Registration Mode; Displaying And Maintaining Gvrp - H3C S5100-SI Operation Manual

Table 1-2 Relations between the timers
Timer
Hold
Join
Leave
LeaveAll
The following are recommended GVRP timer settings:
GARP hold timer: 100 centiseconds (1 second)
GARP Join timer: 600 centiseconds (6 seconds)
GARP Leave timer: 3000 centiseconds (30 seconds)
GARP LeaveAll timer: 120000 centiseconds (2 minutes)

Configuring GVRP Port Registration Mode

Follow these steps to configure GVRP port registration mode:
To do ...
Enter system view
Enter Ethernet port view
Configure GVRP port
registration mode

Displaying and Maintaining GVRP

To do ...
Display GARP statistics
Lower threshold
10 centiseconds
This lower threshold is greater than or
equal to twice the timeout time of the
Hold timer. You can change the
threshold by changing the timeout time
of the Hold timer.
This lower threshold is greater than twice
the timeout time of the Join timer. You
can change the threshold by changing
the timeout time of the Join timer.
This lower threshold is greater than the
timeout time of the Leave timer. You can
change threshold by changing the
timeout time of the Leave timer.
Use the command ...
system-view
interface interface-type
interface-number
gvrp registration { fixed |
forbidden | normal }
Use the command ...
display garp statistics
[ interface interface-list ]
This upper threshold is less than or
equal to one-half of the timeout time of
the Join timer. You can change the
threshold by changing the timeout time
of the Join timer.
This upper threshold is less than
one-half of the timeout time of the Leave
timer. You can change the threshold by
changing the timeout time of the Leave
timer.
This upper threshold is less than the
timeout time of the LeaveAll timer. You
can change the threshold by changing
the timeout time of the LeaveAll timer.
32,765 centiseconds
—
—
Optional
By default, GVRP port registration
mode is normal.
Available in any view
1-6
Upper threshold
Remarks
Remarks