Gvrp; Gvrp Registration - H3C S5120-EI Series Command Reference Manual

<Sysname> system-view
[Sysname] garp timer leaveall 100

gvrp

Syntax
gvrp
undo gvrp
View
System view, Ethernet interface view, Layer-2 aggregate interface view, port group view
Default level
2: System level
Parameters
None
Description
Use the gvrp command to enable GVRP.
Use the undo gvrp command to disable GVRP.
By default, GVRP is disabled.
Note that:
• Settings in system view take effect globally; Settings in Ethernet view or Layer 2 aggregate interface
take effect on the current interface. Settings in port group view take effect on all ports in the port
group.
To enable GVRP on a port, enable GVRP globally first and then on the port.
•
• You can use this command on trunk ports only.
You cannot change the link type of a GVRP-enabled trunk port.
•
Related commands: display gvrp status.
Examples
# Enable GVRP globally.
<Sysname> system-view
[Sysname] gvrp
GVRP is enabled globally.

gvrp registration

Syntax
gvrp registration { fixed | forbidden | normal }
undo gvrp registration
View
Ethernet interface view, Layer-2 aggregate interface view, port group view
194