Display Packet-Filter - H3C S3100 Series Command Manual

Command Manual (For Soliton) – ACL
H3C S3100 Series Ethernet Switches

1.1.6 display packet-filter

Syntax
display packet-filter { global | interface interface-type interface-number | port-group
[ group-id ] | unitid unit-id | vlan [ vlan-id ] }
View
Any view
Parameter
global: Displays information about global packet filtering.
interface interface-type interface-number: Displays information about packet filtering
on the port specified by interface-type and interface-number.
port-group group-id: Displays information about packet filtering on the port group
specified by group-id.
unitid unit-id: Displays information about packet filtering on the unit specified by unit-id.
The unit ID can be set only to 1.
vlan vlan-id: Displays information about packet filtering on the VLAN specified by
vlan-id.
Description
Use the display packet-filter command to display information about packet filtering.
Example
# Display information about packet filtering on the switch.
<Sysname> display packet-filter unitid 1
Ethernet1/0/1
Inbound:
Acl 2000 rule 0
Table 1-3 Description on the fields of the display packet-filter command
Ethernet1/0/1
Inbound
Acl 2000 rule 0
running
running
Field
Packet filtering is performed on Ethernet1/0/1.
Packet filtering is performed in the inbound direction.
The rule 0 of ACL 2000 is used.
Status of the rule, which can be
running: The ACL rule is active.
not running: The ACL rule is inactive. Usually, this is
because the current time is out of the rule's time range.
Chapter 1 ACL Configuration Commands
Description
1-6