Configuring Gvrp Port Registration Mode - H3C S5100-SI Series Operation Manual

Operation Manual – GVRP
H3C S5100-SI/EI Series Ethernet Switches
Table 1-2 Relations between the timers
Timer
Hold
Join
Leave
LeaveAll
Note:
The following are recommended GVRP timer settings:
GARP hold timer: 100 centiseconds (1 second)
GARP Join timer: 600 centiseconds (6 seconds)
GARP Leave timer: 3000 centiseconds (30 seconds)
GARP LeaveAll timer: 120000 centiseconds (2 minutes)

1.2.4 Configuring GVRP Port Registration Mode

Follow these steps to configure GVRP port registration mode:
Enter system view
Enter Ethernet port
view
Configure GVRP port
registration mode
Lower threshold
10 centiseconds
This lower threshold is greater
than or equal to twice the timeout
time of the Hold timer. You can
change the threshold by changing
the timeout time of the Hold timer.
This lower threshold is greater
than twice the timeout time of the
Join timer. You can change the
threshold by changing the timeout
time of the Join timer.
This lower threshold is greater
than the timeout time of the Leave
timer. You can change threshold
by changing the timeout time of
the Leave timer.
To do ... Use the command ...
system-view
interface interface-type
interface-number
gvrp registration { fixed |
forbidden | normal }
This upper threshold is less than
or equal to one-half of the timeout
time of the Join timer. You can
change the threshold by changing
the timeout time of the Join timer.
This upper threshold is less than
one-half of the timeout time of the
Leave timer. You can change the
threshold by changing the timeout
time of the Leave timer.
This upper threshold is less than
the timeout time of the LeaveAll
timer. You can change the
threshold by changing the timeout
time of the LeaveAll timer.
32,765 centiseconds
—
—
Optional
By default, GVRP port
registration mode is normal.
1-7
Chapter 1 GVRP Configuration
Upper threshold
Remarks