Cluster Configuration Commands - H3C S3100 Series Command Manual

Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
forwards the request through the next port. You can use the ntdp timer port-delay
command to set the delay.
You can use the command on a collecting switch. The delay value you set by the ntdp
timer port-delay command is carried in the topology collection requests sent by the
collecting switch, and is used by collected devices to determine the topology collection
request forwarding delay between two ports.
Examples
# Set the port forwarding delay for collected switches to forward NTDP requests to 40
ms.
<aaa_0.Sysname> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Sysname] ntdp timer port-delay 40

2.3 Cluster Configuration Commands

2.3.1 add-member
Syntax
add-member [ member-number ] mac-address H-H-H [ password password ]
View
Cluster view
Parameters
member-number: Member number assigned to the candidate device to be added to the
cluster. This argument ranges from 1 to 255.
H-H-H: MAC address of the candidate device to be added (in hexadecimal).
password: Super password of the candidate device, a string of 1 to 256 characters.
Password authentication is required when you add a candidate device to a cluster. If
the input password is not consistent with the super password configured on the
candidate device (through the super password command, refer to the CLI part of the
manual), you cannot add the candidate device to the cluster. If a candidate device is not
configured with a super password, you can add it to the cluster without providing the
password argument).
Description
Use the add-member command to add a candidate device to the cluster.
You can only use this command on the management device of a cluster.
If you do not specify the member number when adding a new cluster member, the
management device assigns the next available member number to the new member. If
Chapter 2 HGMP V2 Configuration
2-15
Commands