H3C S3100 Series Command Manual page 909

Command Manual (For Soliton) – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches
Diagnostic-information
N=display)?[Y/N]n
-------------------- display version --------------------
......
<Omitted>
1.3.3 terminal debugging
Syntax
terminal debugging
undo terminal debugging
View
User view
Parameter
None
Description
Use the terminal debugging command to enable terminal display for debugging
information.
Use the undo terminal debugging command to disable terminal display for debugging
information.
By default, terminal display for debugging information is disabled.
Note that:
To display the debugging information on the terminal, you need to configure both
the terminal debugging and terminal monitor commands.
If you execute the undo terminal monitor command, you will disable the
monitoring of the log, trap, and debugging information on the current terminal.
Thereby, no log, trap, or debugging information will be displayed on the terminal.
The configuration of the terminal debugging command takes effect for the
current connection only. If the terminal re-establishes a connection, the terminal
display for debugging information is disabled.
Related commands: debugging.
Example
# Enable terminal display for debugging information.
<Sysname> terminal debugging
% Current terminal debugging is on
is saved to
1-11
Chapter 1 Basic System
Configuration and Debugging
Flash or displayed(Y=save
Commands