Loopback-Detection Shutdown Enable - H3C S3100 Series Command Manual

Command Manual (For Soliton) – Port Basic Configuration
H3C S3100 Series Ethernet Switches
View
Ethernet port view
Parameter
None
Description
Use the loopback-detection per-vlan enable command to configure the system to
run loopback detection on all VLANs of the current trunk or hybrid port.
Use the undo loopback-detection per-vlan enable command to restore the default
setting.
By default, the system runs loopback detection only on the default VLAN of the trunk or
hybrid port.
Note that the command is invalid for any access port.
Example
# Configure the system to run loopback detection on all VLANs of the trunk port
Ethernet1/0/1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] port link-type trunk
[Sysname-Ethernet1/0/1] loopback-detection per-vlan enable

1.1.24 loopback-detection shutdown enable

Syntax
loopback-detection shutdown enable
undo loopback-detection shutdown enable
View
Ethernet port view
Parameter
None
Description
Use the loopback-detection shutdown enable command to enable the loopback port
auto-shutdown function.
Chapter 1 Port Basic Configuration
1-29
Commands