Copy Configuration - H3C S3100 Series Command Manual

Command Manual (For Soliton) – Port Basic Configuration
H3C S3100 Series Ethernet Switches
When incoming broadcast traffic exceeds the broadcast traffic threshold you set, the
system drops the packets exceeding the threshold to reduce the broadcast traffic ratio
to the specified range, so as to keep normal network service.
You can use the undo broadcast-suppression command in system view to cancel the
broadcast suppression settings on all ports, or use the broadcast-suppression
command in system view to make a global setting.
Executing the commands in Ethernet port view only takes effect on the current port.
Note:
If you configure broadcast-suppression command in both system view and Ethernet
port view, the configuration in Ethernet port view will take effect.
With the Traffic Policing enabled, broadcast-suppression function cannot be
enabled either on System view or Ethernet port view. Refer to the QoS part for
information about Traffic Policing.
Example
# Allow incoming broadcast traffic on all port to occupy at most 20% of the total
transmission capacity of the port and suppress the broadcast traffic that exceeds the
specified range.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] broadcast-suppression 20
Note:Broadcast-suppression is set successfully on all ports except reflector
ports, fabric ports and the port configured storm-constrain!
# Set the maximum incoming broadcast traffic rate allowed on Ethernet 1/0/2 to 128
kbps.
[Sysname] interface Ethernet 1/0/2
[Sysname-Ethernet1/0/2] broadcast-suppression bps 128

1.1.2 copy configuration

Syntax
copy configuration source { interface-type interface-number | aggregation-group
source-agg-id } destination { interface-list [ aggregation-group destination-agg-id ] |
aggregation-group destination-agg-id }
View
System view
Chapter 1 Port Basic Configuration
1-2
Commands