H3C S3100 Series Command Manual page 177

Command Manual (For Soliton) – Port Basic Configuration
H3C S3100 Series Ethernet Switches
Output(normal): - packets, - bytes
output errors
- underruns
- buffer failures
aborts
deferred
collisions
late collisions
lost carrier
- no carrier
Field
- broadcasts, -
multicasts, - pauses
1-12
Chapter 1 Port Basic Configuration
Description
Count in packets and in bytes of
outgoing normal packets on the port,
including outgoing normal packets and
normal Pause frames.
The number of normal outgoing
broadcast packets, the number of
normal outgoing multicast packets, and
the number of normal outgoing Pause
frames on the port.
A hyphen (-) indicates that the statistical
item is not supported.
The total number of outgoing error
frames
The number of packets dropped
because the transmitting rate of the port
exceeds the processing capacity of the
output queue, which is a rare hardware
error.
The number of packets dropped due to
insufficient transmit buffer on the port
The number of transmission failures due
to various reasons, such as collisions
The number of first transmission
attempts delayed because of detection
of collisions
The number of detected collisions
(Transmission of a frame will be aborted
upon detection of a collision.)
The number of detected late collisions
(A late collision occurs if the
transmission of a frame defers due to
detection of collision after its first 512 bits
have been transmitted.)
The lost carrier counter applicable to
serial WAN interfaces
The counter increases by 1 upon each
carrier loss detected during frame
transmission.
The no carrier counter applicable to
serial WAN interfaces
The counter increases by 1 upon each
carrier detection failure for frame
transmission.
Commands