Display Cluster Candidates - H3C S3100 Series Command Manual

Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Administrator device mac address:000f-e20f-3901
Administrator status:Up
Table 2-5 Description on the fields of the display cluster command
Cluster name
Role
Management-vlan
Member number
Handshake timer
Handshake hold-time
Administrator device mac address
Administrator status

2.3.12 display cluster candidates

Syntax
display cluster candidates [ mac-address H-H-H | verbose ]
View
Any view
Parameters
mac-address H-H-H: Specifies a candidate device by its MAC address. H-H-H
represents the MAC address.
verbose: Displays detailed information about candidate devices.
Description
Use the display cluster candidates command to display information about one
specified or all candidate devices of a cluster.
You can only use this command on a management device.
Note that, after a cluster is set up on an S3600 series switch, the switch will collect the
topology information of the network at the topology collection interval you set and
Field
2-29
Chapter 2 HGMP V2 Configuration
Description
Name of the cluster, which can be configured
through the build command
Role of this switch
Number of the management VLAN, which can
be configured through the management-vlan
command
Member number of this switch
Interval to send handshake packets, which
can be configured through the timer
command
Holdtime of the neighbor status information,
which can be configured through the
holdtime command
MAC address of the management device
Status of the management device
Commands