Display Cluster - H3C S3100 Series Command Manual

Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Description
Use the delete-member command to remove a member device from the cluster.
Note that a cluster will collect the topology information at the topology collection interval.
If you do not add a device to the cluster blacklist when removing it from the cluster, the
device will be added to the cluster again when the cluster collects topology information.
Therefore, to remove a device from a cluster permanently, you can use the following
methods:
Use the delete-member command with the to-black-list keyword specified to
remove a device and add the device to the blacklist of the cluster.
Before using the delete-member command to remove a device from the cluster,
use the undo ndp enable and undo ntdp enable command to disable NDP and
NTDP on the ports of the device which connect with the cluster member devices.
Note:
This command is applicable to management devices only.
Related commands: add-member.
Examples
# Remove the member device numbered 4 from the cluster, and add it to the cluster
blacklist.
<aaa_0.Sysname> system-view
Enter system view, return to user view with Ctrl+Z.
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] delete-member 4 to-black-list

2.3.11 display cluster

Syntax
display cluster
View
Any view
Parameters
None
Chapter 2 HGMP V2 Configuration
2-27
Commands