H3C S3100 Series Command Manual page 173

Command Manual (For Soliton) – Port Basic Configuration
H3C S3100 Series Ethernet Switches
For details about the arguments, refer to the parameter description of the interface
command.
Description
Use the display interface command to display port configuration.
When using this command:
If you specify neither port type nor port number, the command displays information
about all ports.
If you specify only port type, the command displays information about all ports of the
specified type.
If you specify both port type and port number, the command displays information about
the specified port.
Example
# Display the configuration information of the Ethernet1/0/1 port.
<Sysname> display interface ethernet1/0/1
Ethernet1/0/1 current state : DOWN
IP Sending
0012-a990-2240
Media type is twisted pair, loopback not set
Port hardware type is 100_BASE_TX
100Mbps-speed mode, full-duplex mode
Link speed type is force link, link duplex type is force link
Flow-control is enabled
The Maximum Frame Length is 2048
Broadcast MAX-bps: 128K
Multicast MAX-pps: 128K
Allow jumbo frame to pass
PVID: 1
Mdi type: auto
Port link-type: access
Tagged
Untagged VLAN ID : 1
Last 300 seconds input:
Last 300 seconds output:
Input(total):
Input(normal):
Input:
Frames' Format
VLAN ID : none
0 packets/sec 0 bytes/sec
0 packets/sec 0 bytes/sec
0 packets, 0 bytes
0 broadcasts, 0 multicasts, - pauses
- packets, - bytes
- broadcasts, - multicasts, - pauses
0 input errors, 0 runts, 0 giants,
0 frame, - overruns, 0 aborts, 0 ignored, - parity errors
Chapter 1 Port Basic Configuration
is PKTFMT_ETHNT_2,
- throttles, 0 CRC
1-8
Commands
Hardware address is