H3C S3100 Series Command Manual page 692

Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
If to-mac-address or to-member-id is specified, the system displays the topology
structure of the route between the two specified MAC addresses or two member IDs.
Note:
When you display the cluster topology information, the devices attached to the switch
that is listed in the backlist will not be displayed.
Examples
# Display the topology of the current cluster.
<aaa_0.Sysname> display cluster current-topology
--------------------------------------------------------------------
(PeerPort) ConnectFlag (NativePort) [SysName:DeviceMac]
--------------------------------------------------------------------
ConnectFlag:
<--> normal connect
???? lost device
--------------------------------------------------------------------
[aaa_0.H3C:000f-e202-2180]
|
├-(P_0/40)<-->(P_0/6)[Sysname:000f-e200-2200]
|
├-(P_0/28)<-->(P_3/0/1)[Sysname:000f-e200-1774]
|
├-(P_0/24)****(P_1/0/6)[clie:000f-e200-5502]
|
├-(P_0/22)<-->(P_1/0/2)[aaa_5.H3C:000f-e200-5111]
|
├-(P_0/18)<-->(P_3/0/2)[Sysname S7503S3600:000f-e218-d0d0]
|
├-(P_0/14)<-->(P_1/0/2)[Sysname:000f-e200-5601]
|
├-(P_0/10)<-->(P_1/0/1)[aaa_7.S5500-28C-SI:0012-a990-2241]
|
├-(P_0/4)<-->(P_0/2)[2024CS3600:000f-e200-00cc]
|
└-(P_0/1)****(P_0/1)[Sysname:00e0-fd34-bc66]
Chapter 2 HGMP V2 Configuration
---> odd connect
++++ new device
2-50
Commands
**** in blacklist
-┤├- STP discarding