AddPac VoiceFinder AP200 User Manual page 97

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
[Procedure-DHCP Server]
Order
1
2
3
4
5
6
7
8
[Procedure – DHCP Client ]
순서
1
2
3
[Related Commands and Syntax]
Mandatory Commands
dhcp-list <dhcp-list-number> type {server/relay}
Creates the DHCP list of the Gateway (dhcp-list-number: any number
between 0 and 4) and sets DHCP in the list should function as a server or
protocol relay.
AddPac Technology Co.,Ltd.
Move to the configuration mode.
Define the DHCP-list type to use in the Gateway.
Create a DHCP-list defining DHCP-list number, DHCP mode to use in
the Gateway, or DHCP address pool.
If the server type is DHCP, set a DHCP pool that defines the
DHCP start-address and the DHCP end-address.
If the server type is DHCP, set a DHCP pool that defines the
DHCP start-address and the DHCP end-address.
Set other DHCPs and other necessary options.
Go to the interface configuration mode.
Enter into the IP configuration mode.
Apply the DHCP-list that has been set to the corresponding interface.
Use "Show dhcp-list" to check if desired DHCP has been correctly set.
Move to the configuration mode.
Select the interface configure as a DHCP Client
Apply the DHCP-Client instead of IP Address to the corresponding
interface
Operation
작업 내용 Description
97
- -