AddPac VoiceFinder AP200 User Manual page 106

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
[Example] Transparent Bridging Configuration and Usage
router# config
router(config)# interface Ethernet 0.0
interface 0.0 and starts configuration.
router(config-ether0.0)# bridge ☞ Applies bridge to Ethernet
interface 0.0.
router(config-ether0.0)# bridge priority 2
spanning tree priority of the interface as 2.
router(config-ether0.0)# interface serial 0
the configuration mode of the interface serial 0.
router(config-serial0)#
Encapsulates with the frame-relay.
router(config-serial0)# frame-relay map bridge 100
Enables the bridge in the frame-relay interface. This command
also encapsulates the bridge packet.
router(config-serial0)# exit
configuration mode.
router(config)# bridge forward-time 150
forward delay interval as 150 seconds.
router(config)# bridge hello-time 5
BPDU interval as five seconds.
router(config)# bridge max-age 150
to wait until receiving BPDU from the root bridge as 150 seconds.
router(config)# exit
router # show running-config
interface ether0.0
!
interface serial0
AddPac Technology Co.,Ltd.
no ip address
Operation is UP
bridge
no ip address
Encapsulation FRAME-RELAY
encapsulation
☞ Goes back to the global
☞ Sets the bridge hello
☞ Sets the standby time
☞ Exists from the configuration mode.
☞ Shows configuration contents.
☞ Creates Ethernet
☞ Sets the
☞ Enters into
frame-relay
☞ Sets the bridge
106
-
☞
☞
-