Preference - AddPac VoiceFinder AP200 User Manual

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
5.7.4.8.3. Command Mode
Dial-Peer Configuration Mode
5.7.4.8.4. Usage Guideline
This command is applicable only to POTS peers .
Use the port configuration command to associate the designated voice port
with the selected dial peer.
This command is used for calls incoming from a telephony interface to select
an incoming dial peer and for calls coming from the VoIP network to match a
port with the selected outgoing dial peer.
5.7.4.8.5. Examples
The following example associates a dial peer with voice port:
dial-peer voice 10 pots
port 1/1
5.7.4.9.

preference

To clearly designate priorities within the hunt group for a certain dial-peer, use
"preference" command in the dial-peer setup mode. To use default priorities,
use "no" command before "preference" command.
preference value
no preference
5.7.4.9.1. Syntax
Keyword / Argument
value
AddPac Technology Co.,Ltd.
Description
Values range from 0 to 9, and the lower the value
is, the higher the priority is.
241
- -