Fax Rate - AddPac VoiceFinder AP200 User Manual

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
bypass
redundancy
value
5.7.5.5.2. Default Value
T.38 fax protocol
5.7.5.5.3. Command Mode
Voice-Service Configuration Mode
5.7.5.5.4. Usage Guideline
Use the fax protocol t38 command to configure T.38 Fax Relay for VoIP. The t38
keyword enables the T.38 Fax Relay protocol.
Optional parameters redundancy is used to send redundant T.38 fax packets.
5.7.5.5.5. Examples
The following example shows T.38 fax protocol for VoIP, beginning in global
configuration mode:
VoIP service VoIP
fax protocol t38
5.7.5.6.

fax rate

To establish the rate at which a fax is sent to the specified dial peer, use the fax
rate command in dial-peer configuration mode.
To reset the dial peer for voice calls, use the no form of the command.
fax rate { 2400 | 4800 |7200 | 9600 | 12000 | 14400 |disable }
no fax rate
AddPac Technology Co.,Ltd.
Fax protocol on clean voice channel (i.e., G.711)
(Optional) redundancy for the T.38 fax protocol.
The value can be from 0 to 5. The default is 0..
The value can be from 0 to 5. The default is 0.
258
- -