AddPac VoiceFinder AP200 User Manual page 71

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
[Example] Added Commands During PAP Configuration (Client)
This is when the AP200 Gateway is used as a PPP CallIn on the client side.
Router (config)#interface ethernet0.0
interface configuration mode.
Router(config-ethernet0.0)# encapsulation ppp
mode.
Router(config-ethernet0.0)# ppp authentication pap
the PPP authentication mode as PAP for the ethernet0.0 interface.
Router(config-ethernet0.0)# ppp pap sent-username addpac
password Router1
were saved in the server during PPP connection.
Router(config-ethernet0.0)# ppp timeout 100
connection negotiation timeout value as 100 seconds.
Router(config-ethernet0.0)#
configuration menu.
Router # debug ppp packet
Router # debug ppp packet
Caution
If the interface of the Gateway is not used as DHCP, the IP address
must be set in the corresponding interface.
AddPac Technology Co.,Ltd.
☞ Sends the user name and the password that
Ethernet0 LCP: TIMEOUT
Ethernet0 LCP: O CONFREQ id=1
Ethernet0 BCP: TIMEOUT
Ethernet0 BCP: O CONFREQ id=1
Ethernet0 LCP: TIMEOUT
Ethernet0 LCP: O CONFREQ id=1
Ethernet0 BCP: TIMEOUT
Ethernet0 BCP: O CONFREQ id=1
☞ Enters into the
☞
end
Exists
☞ Stops PPP packet debugging.
☞ Sets the PPP
☞ Sets
☞ Sets PPP
from the
71
- -