Debug Commands - AddPac VoiceFinder AP200 User Manual

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
4.13.3.

Debug Commands

Information
Debug commands decodes certain packets that pass through Gateway
devices and indicate whether packets are normal or not to the manager.
Therefore, the manager can check whether the network or device has been
normally set up or not. Debug commands can be used in the Exec mode.
Caution
Note that Debug commands use a lot of system resources. Therefore, minimize
the range of using Debug commands. Also, since Debug commands greatly
lower general performances of the system, turn off Debug commands.
"debug" command can be used in the Exec mode, and its syntax is as follows:
debug {option}: Enables debugging.
no debug {option}: Enables debugging that has been set.
undebug {option}: Disables debugging.
Debug related optional commands are as follows:
ppp {chap/error/negotiation/packet }
1. Decodes and shows configuration and operation status of PPP.
2. Details of each option are as follows:
AddPac Technology Co.,Ltd.
1) chap: Decodes and shows information exchanged when CHAP is
being set.
2) error: Decodes and shows error information in the PPP process.
3) negotiation: Decodes and shows PPP link negotiation information.
4) packet: Decodes PPP packets.
125
- -