Dial-Peer Terminator - AddPac VoiceFinder AP200 User Manual

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
operator. Although this pre-configured method is easy and secure, making a
call by end-user with IP address of destination terminal is useful to call to
ubiquitous VoIP terminal and gateway.
This prefix is used to discriminate normal call with number digits and direct call
with IP address. To solve conflicting with terminator character, terminator
character and ip address prefix character are changed automatically when
configuring it.
5.7.2.2.5. Examples
The following example configures * as the special ip address prefix character:
configure
dial-peer ipaddr-prex *
The following example shows digit sequence for making a call by IP address. If
IP address is 127.0.1.1 and called party number is 1234 then sequence of digits
to making that call is:
* 10 * 0 * 0 * 1 * 1234 #
In above sequence, the first digit is ipaddr-prefix and the ipaddr-prefix
character is used to discriminate IP address dot. And the last digit is terminator
character.
When the destination terminal is simple VoIP phone like Microsoft Netmeeting,
sequence of digits would be:
* 10 * 0 * 0 * 1 #
5.7.2.3.

dial-peer terminator

To designate a special character to be used as a terminator for variable length
dialed numbers, use the dial-peer terminator global configuration command.
Use the no form of this command to default setting.
AddPac Technology Co.,Ltd.
198
- -