AddPac VoiceFinder AP200 User Manual page 156

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
5.3.2.4.2. Setting VAD in the VoIP Dial Peer
To disable transmission of silent packets for the selected VoIP, use the following
commands in the global setup mode (start.)
Step
1 dial-peer voice
2 vad
In the default status, the VAD is enabled. Normally, the default is the most
suitable.
However, to connect to a network with a high bandwidth or to get the best
voice quality, disable the VAD.
By disabling the VAD, users can get better voice quality but more bandwidth is
required for the voice session.
To enable the VAD for the VoIP dial peer 108, set the VAD as follows:
dial-peer voice 108 VoIP
destination-pattern 14085551234
vad
session target 10.0.0.8
AddPac Technology Co.,Ltd.
Command
number
VoIP
Description
Enters into the dial-peer setup mode to set the
VoIP peer.
Disables transmission of silent packets.
In other words, enables the VAD.
156
- -