Voice Class User - AddPac VoiceFinder AP200 User Manual

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
5.7.2.10.4. Usage Guideline
This command only creates the voice class for codec selection preference and
assigns an identification tag. Use the codec preference command to specify
the parameters of the voice class, and use the voice-class codec dial-peer
command to apply the voice class to a VoIP dial peer.
5.7.2.10.5. Examples
The following example shows how to enter voice-class configuration mode and
assign a voice class tag number starting from global configuration mode:
voice class codec 10
After you enter voice-class configuration mode for codecs, use the codec
preference command to specify the parameters of the voice class.
The following example creates preference list 99, which can be applied to any
dial peer:
configure
voice class codec 99
codec preference 1 g711alaw
codec preference 2 g711ulaw
codec preference 3 g729
codec preference 4 g7231r63
codec preference 5 g7231r53
exit
5.7.2.11.

voice class user

To enter user-class configuration mode and assign an identification tag number
for a user class, use the voice class user command in global configuration
mode. To delete a user voice class, use the no form of this command.
voice class user tag
no voice class user tag
AddPac Technology Co.,Ltd.
210
- -