AddPac VoiceFinder AP200 User Manual page 87

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
unregistered IP addresses into a protocol port number on an external,
registered IP address.
1. The VoiceFinder AP200 Gateway currently supports only dynamic address
translation.
2. The VoiceFinder AP200 Gateway supports 256 NAT addresses.
3. The VoiceFinder AP200 Gateway only static routing for NAT.
[Procedure]
Order
[Related Commands and Syntax]
nat <nat-list-number> nat outside-global <start-address> <end-address>
<mask>
1. Creates NAT pool for the outside global address in the global
AddPac Technology Co.,Ltd.
1 Move to the configuration mode.
Create the NAT/PAT-list defining the official address to use.
At this time, decide where to use the global address – inside or
outside.
Define and set the entry to statistically match address
2 translation between the inside address and the outside
address.
The user needs to set timeout value of the session and
recovery of the allocated address for the idle status when no
data is transmitted through NAT.
3 Go to the interface configuration mode.
4 Enter into the IP configuration mode.
Apply the NAT/PAT-List that has been set to the corresponding
5
interface.
Use "Show nat-list" command to check if correct access-list has
6
been set.
Operation
87
- -