Voice-Class Codec - AddPac VoiceFinder AP200 User Manual

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
5.7.4.16.1. Syntax
This command has no arguments or keywords.
5.7.4.16.2. Default Value
Enable
5.7.4.16.3. Command Mode
Dial-Peer Configuration Mode
5.7.4.16.4. Usage Guideline
Use the vad command to enable voice activity detection. With VAD, silence is
not transmitted over the network, only audible speech. If you enable VAD, the
sound quality is slightly degraded but the connection monopolizes much less
bandwidth.
If you use the no form of this command, VAD is disabled and voice data is
continuously transmitted to the IP backbone.
5.7.4.16.5. Examples
The following example enables VAD:
dial-peer voice 10 VoIP
vad
5.7.4.17.

voice-class codec

To assign a previously configured codec selection preference list (codec voice
class) to a VoIP dial peer, enter the voice-class codec command in dial-peer
configuration mode. To remove the codec preference assignment from the
dial peer, use the no form of this command.
voice-class codec tag
no voice-class codec tag
AddPac Technology Co.,Ltd.
251
- -