AddPac VoiceFinder AP200 User Manual page 76

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
[Procedure]
Order
1
2
3
4
5
Caution
The next-hop address to set during setting up the static route shall be directly
connected with the Gateway to set.
The default route is one of static routes, and the setting method of the default
route is same as that of the static route. However, the destination address shall
be zero subnet (0.0.0.0 address and 0.0.0.0
[Related Commands and Syntax]
router static
Enables or disables a certain routing process.
route <destination-IP-network> <address-mask> { <next-hop-address> /
Ethernet / null } [ ( 0/1)/<null_int_#> ] [sub_int_#]
1.
2.
3.
AddPac Technology Co.,Ltd.
Go to the configuration mode.
Enable the static Gateway process.
Set the source address and the static route for the destination network.
Use "show" command and check if the route is correctly set in the routing
table.
With "Ping" command, check if the route can reach the network.
mask) in the zero network, and the next-hop address shall be same
with that of the static route.
Designates the route to send the packet to the destination address.
When using the candidate default (default route,) both of the
destination address
The Gateway shall be able to recognize the "next-hop-address"
(directly connected port or where the Gateway can reach through
dynamic protocol.)
Operation
and the mask filed shall be zero.
76
- -