AddPac VoiceFinder AP200 User Manual page 62

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
2. {0/1} represents the main interface while [logical I/F #] represents the
3. The Ethernet shall be set as a sub-interface, and if the manager needs
1. Sets the IP address for the selected interface.
2. One of lower commands of "ip" command
[Example] Ethernet Configuration (Start)
When
210.10.2.1/24Bits"
1Router(config)# interface ethernet 0 0
2Router(config-ether0.0)# ip address 192.20.1.1 255.255.255.0
3Router(config-ether0.0)# interface ethernet 0 1
4Router(config-ether0.1)# ip address 210.10.2.1 255.255.255.0
1. An optional command to change the encapsulation method for the
2. The default is the Ethernet.
3. VLAN supports 802.1Q VLAN.
4. PPPoE supports ADSL Service
1.
2.
Forces the Gateway to send the ARP (MAC) request for the corresponding
address. (Usually used for the test.)
AddPac Technology Co.,Ltd.
configuration mode.
sub-interface.
to use the frame-relay encapsulation, the serial interface can be set as
a sub-interface.
ip address <ip_address> <net_mask>
operating "Primary
encapsulation {Ethernet/ieee/vlan/pppoe}
current Ethernet interface
mtu <mtu-size>
Sets the MTU size for the current interface.
The default is 1,500 Bytes.
arp request <ip-address>
arp static <ip-address> <hardware(MAC)-address>
IP: 192.20.1.1/24bits, Secondary IP:
62
- -