AddPac VoiceFinder AP200 User Manual page 208

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
voice class clear-down-tone tag lowFreq highFreq onTime offTime
no voice class clear-down-tone tag
5.7.2.9.1. Syntax
Keyword / Argument
tag
lowFreq
highFreq
onTime
offTime
5.7.2.9.2. Default Value
No Default Value
5.7.2.9.3. Command Mode
Global Configuration Mode
5.7.2.9.4. Usage Guideline
Call termination of FXO voice-port is established through detection of
clear-down tone from PSTN or PBX, which is connected with FXO port. This
clear-down tone(Ex: busy tone, fast busy tone) is different from each PSTN and
PB. So, handle it as registering by this command.
This command is to enable to user to set detection tones in addition to
clear-down-tone provided by the system.
provided by the system and shown in the clear-down-tone is enough,
AddPac Technology Co.,Ltd.
Specifies the clear down tone.
Valid entries are from 0 to 1.
Specifies the low frequency, of Hz, of the
clear-down tone provided by the local switch or
PBX.
The frequency range is from 300Hz to 1980 Hz
Specifies the high frequency, of Hz, of the
clear-down tone provided by the local switch or
PBX.
The frequency range is from 300Hz to 1980 Hz. In
case of single tone, value is 0.
Specifies the on-time duration of clear down tone.
Specifies the off-time duration of clear down tone.
In case of long duration tone, value is 0.
If the default detection tone
Description
208
- -