AddPac VoiceFinder AP200 User Manual page 88

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
2. NAT-list-number: Define any number between 0 and 7.
3. Start-address/End Address/Mask: Define the start address and the end
<local-ip address >
1. Creates a Nap pool for the outside global address in the global
2. NAT-list-number: Define any number between 0 and 7.
3. Start-address/End Address: Designate the start address and the end
4. Local –IP-Address: When there is a subnet that uses a registered IP in the
nat
<outside-global-address>
1. When it is necessary to access servers in the local network from outside,
2. NAT-list-number: Define any number between 0 and 7.
3. Start-address/End Address: Define the start address and the end
nat <nat-list-number> nat time-out <timer-value>
1. Defines time value for the NAT list to recover the address into free status
2. The default is 300 seconds.
nat-group <nat-list-number> {nat/pat}
As an interface command, Applies the NAT-list that has been set in the
global mode to the corresponding interface.
AddPac Technology Co.,Ltd.
configuration location.
address of NAT and the subnet masks for these addresses.
nat <nat-list-number> nat inside-global <start-address> <end-address>
configuration location.
address to use in the NAT.
local network, the user can register this subnet in the outside interface
to route and advertise the subnet to the outside network.
<nat-list-number>
the user can define static entry for address translation with this
command.
address that NAT uses.
when communication is idle.
natstatic-entry<inside-local-address>
88
- -