Chapter 4. Gateway Configuration And Commands; Gateway Booting - AddPac VoiceFinder AP200 User Manual

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1

Chapter 4. Gateway Configuration and Commands

This chapter describers how to configure the VoiceFinder AP200 Gateway and
commands of the VoiceFinder AP200 Gateway.
4.1.

Gateway Booting

The operator can use all commands of the AP200 through the consol or Telnet
connection.
When power is supplied, the Gateway is booted as follows :
The Gateway performs a self-test and checks basic operations of the CPU,
the memory and interfaces.
The boot loader is executed, and the boot loader seeks for proper
Gateway software image files.
loader loads Gateway software in the flash memory.
If the boot loader does not find any proper Gateway software image file
from the flash memory, the boot loader stands by in the boot mode until it
receives proper Gateway software from the system.
boot loader can download Gateway software through TFTP or FTP
protocol.)
When Gateway software is loaded, Gateway starts to operate according
to configuration information saved in the Gateway. However, if there is no
configuration information, the Gateway operates according to the default
values, and in this case, the operator shall set up related items for normal
operation of the network.
AddPac Technology Co.,Ltd.
In the default configuration, the boot
(At this time, the
46
- -