Other Voip Configuration; Setting H.323 Gateway - AddPac VoiceFinder AP200 User Manual

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
5.6.

Other VoIP Configuration

5.6.1. Setting H.323 Gateway

H.323 gateway inter-works with the gatekeeper and receives the Registration
Admission and Security (RAS) service. The AP200 Gateway can set static IP
address in the VoIP peer and operate without any gatekeeper.
AP200 Gateway can dynamically bring the IP address (the other party's
number) through the gatekeeper without setting any IP address.
For this, h323 ID of the gateway is necessary, and h323 ID is the only identifier in
the gatekeeper.
Gateway sets the default h323 ID as VoIP.211.123.1.1. Users can set H323 ID in
the gateway setup mode using "h323-id" command.
The AP200 Gateway uses "gkip" command to designate gatekeepers. With
"gkip" command, users can designate more than one gatekeeper and register
them by priorities. There is only one gatekeeper that can be registered at the
same time.
For the security between the gateway and the gatekeeper, users can set the
secure token using "security password" command. However, if the password
is enabled, the gateway will add Crypto Token to the message and send the
message to the gatekeeper.
gatekeeper and cryptoEPPwdHash is supported, this security setup can be
made. At this time, the password is given by the administrator off line.
When the user exits the gateway setup mode by "exit" or "end" gateways start
to be registered in the gatekeeper.
To cancel registration of gateway in the gatekeeper, use "no gateway"
command in the global setup mode.
AddPac Technology Co.,Ltd.
If VoIP IP address of the router is 211.123.1.2, the AP200
Only when CryptoH323Token is set for the
Also, the
184
- -