Applying Translation Rules To The Inbound Pots Calls - AddPac VoiceFinder AP200 User Manual

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
rule 3 [1-9]...... 822%01%02%03%04%05%06%07%08
Created translation rules can be verified by "show translation-rule" command.
For example, "show translation-rule 100" command will show rules of the
translation rule set 100. To view the translation result, enter the number to test.
To check the translation result of "1234" in the translation rule set 100, enter
"show translation-rule 100 1234." At this time, the result will be 1234.
5.3.7.2.

Applying Translation Rules to the Inbound POTS Calls

To apply the translation rule set to all calls received in the voice port, make
following setting.
Step
1 Router# configure
2 Router(config)# voice-port
3 Router(voice-port)# translate-incoming
{called-number | calling-number}
If the translation rule is applied to the called party and if numbers are entered
into the voice port in order, check if translation is made for each number
entered. At this time, translation shall be made only once.
AddPac Technology Co.,Ltd.
Command
location
tag
Description
Enters into the global configuration
mode.
Enters into the designated voice port
configuration mode.
The location is indicated by the
slot-number/port-number.
called-number:
translation rule to the inbound called
party number.
calling-number:
translation rule to the inbound calling
party number.
The tag refers to the rule set and tag
values range from 0 to 65535.
Applies the
Applies the
170
- -