AddPac VoiceFinder AP200 User Manual page 160

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
The sequential decides priorities according to the selection count. The less
selected, the higher priority is given.
This priority algorithm operates using all this factors. For example, operation of
dial-peer hunt 0 decides the first priorities according to the longest matching,
checks the preference order within the same longest match priority, and then
randomly selects the dial peer in the same preference order.
The first setup relating to the hunt group is to select the hunt algorithm.
Step
1 Router# configure
2 Router(config)# dial-peer hunt
[0-7]
Users can also set priorities according to the preference or a huntstop in the
corresponding peer according to the huntstop.
If a huntstop has been already set in a certain dial peer and if an outbound
call going to the dial peer is failed, the call will be terminated without hunting
another dial peer.
Step
1 Router# configure
2 Router(config)# dial-peer voice
VoIP }
3 Router(config-dial-peer)#
number
AddPac Technology Co.,Ltd.
Command
Command
tag
preference
Description
Enters into the global configuration mode.
Algorithm 0 ~ 7 are applied as follows:
0 – (default) longest match, explicit preference,
random
1 - longest match, explicit preference, sequencial
2 - explicit preference, longest match, random
3 - explicit preference, longest match, sequencial
4 – sequencial, longest match, explicit preference
5 - sequencial, explicit preference, longest match
6 – random
7 - sequencial
Enters into the configuration mode.
Enters into the dial-peer configuration
{ pots |
mode.
The tag is the only identifier of the
dial-peer of this system, and tag values
range from 0 to 65535.
The value ranges from 0 to 9, and the
lower the value is, the higher the
priority is.
Description
160
- -