AddPac VoiceFinder AP200 User Manual page 104

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
[Related Commands and Syntax]
bridge
As an interface command, sets that the corresponding interface should
function as a bridge group.
frame-relay map bridge <dlci-number>
1. An interface command. If the interface using the bridge is frame-relay,
2. DLCI values is any number between 16 and 1007.
3. If a bridge is used in the frame-relay interface, the user must use "MAP"
bridge priority <priority-number>
1. An option of the interface command.
2. The range is between 0 and 255. The lower the number is, the higher
bridge path-cost <path-cost-value>
1. An option of the interface command.
2. The range is between 0 and 65535. The lower the number is, the higher
bridge hello-time <hello-interval>
1. An optional command of "Global" command. This command defines
2. The range is between 1 ~ 10 seconds.
AddPac Technology Co.,Ltd.
this command sets the map in a way that the bridge maps can be sent
through this interface.
command to enable the bridge.
priority of the interface to be blocked or forwarded while participating
in the spanning tree procedure.
the priority is. The default is 0.
priority of the interface to be blocked or forwarded while participating
in the spanning tree procedure.
the priority is. The default is 100 for Ethernet or 128 for Serial.
Hello Interval between BPDUs.
seconds.
This command defines the
This command defines the
The default value is two
-
104
-